With the continuous expansion of the high rod light market, the quality of high rod lights is uneven. Once the market expands, entrepreneurs will find that it is profitable. Therefore, the quality of many high rod lights on the market is not very satisfactory for consumers. This is mainly because the manufacturer of high rod lights is a small workshop, and people have a cheap psychology, and usually buy it at the lowest price

purchase. After all, you have to pay the fee to pay. In high quality, the cost will be very high, and the price will naturally rise. Due to customer -oriented, high -quality high -rod light manufacturers are difficult to survive. High -rod lamp manufacturers will introduce high rod lamps for the production of light rods.

1. Formed a high -rod lamp, the welding site should be as smooth as possible, and the error between the protruding part of the welding site and the flatness of the column should be less than 1 mm. The welding method must be automatic arc welding technology, and when it is checked with professional instruments, it must meet international standards. After inserting the power socket, use the nails and wire to fix the power socket.

2. The light rod must be hot -dip galvanized. The coating must be smooth and shiny. Negative and sunny surfaces must be consistent. There should be no peeling, flowing, zinc growth or wrinkles. According to national standards, the thickness of the coating must be greater than 85m, and the adhesion of the zinc layer must also meet the national standards.

3. A layer of all -polyester plastic powder should be sprayed on the surface of the light rod to ensure that the light rod can resist the open -air wind blowing rain. The thickness should be greater than 100m, the hardness should not be less than 2h, and the surface should be smooth and smooth.

4. The light rod must also meet the requirements of non -slip and anti -theft, and the design of the light rod should facilitate the connection of the line. The service life of the light rod is at least 20 years, and its manufacturing and acceptance standards must meet the national requirements.

The above are some requirements for producing high rod lights. Consumers can also judge the quality they purchased from these aspects. By choosing, you can compare the differences between different products. Or let the high -rod lamp manufacturers provide indicators of their products in these aspects.