There are three lines of Phantom Lantern, which are R, G, B, that is, red, green, blue, and these three colors can change tens of thousands of colors. These three lines can be directly connected to the corresponding RGB On the wiring column, the colorful lamp bar has a line that is yellow, which comes through, and this line can be connected to the positive pole.

The RGB line is connected to the negative electrode, the circuit is positive, and the controller controls the negative light bar, which is called the common yang.

LED Phantom Lighting Specification Application and Use

  main feature

The IC control circuit shares a power supply with the LED point light source.

The control circuit and RGB chip are integrated in a 5050 packaging component to form a complete external control pixel.

For a built -in signal plastic surgery circuit, any pixel point receives the signal and is output through waveform plastic surgery to ensure that the line waveform distortion of the line will not be accumulated.

Built -in -on -power reset and power -off reset circuit.

Each pixel -point color color color can be displayed at 256 brightness display, and the full real color display of 16777216 colors is completed.

The port scanning frequency is 2kHz/s.

The serial interface can complete the data receiving and decoding through a signal line.

Any two -point transmission distance does not need to increase any circuit when not more than 5 meters.

When the refresh rate is 30 frames/second, the level couplet is not less than 1024 points.

Data delivery speed can reach 800kbps.

The color of light is consistent and cost -effective.