Design Features

-Adopt 9*22μm chip , golden wire with copper base, CRI>90;

-Chips soldered by high density allocation on the FPCB, light emitting much more smooth and consistent than conventional SMD strip;

-AC110V Constant voltage circuit for flexible cut off as application need, strip has to be cut at the solder joint point;

-FPCB thickness is 3Oz 25/50;

-The COB strip product body thickness is super thin, suitable for special scenario;

-Luminous surface width of 4.5±0.3mm.

RM Detail:

Optical and Physical Specification:

Optoelectronic Parameters:

Application and Installation Instruction

-Suitable for indoor cell roof invisible light decoration, bedroom background light, Neon signage, commercial signage.

-Installation by adhesive tape

-Clean the touch surface of the object before pasting the strip onto the surface.

-Peel off the PE tape from the adhesive tape of the back side of the strip.

-Press the strip onto the surface of the object to fix it.

-Installation by clasp

-Screw up the clasp on the object where you intend to apply the strip

-Kick the strip inside the clasp to make the strip clipped by clasp.

Tips:

-Strip can be cut off as per the backside outstanding cut mark direction, according to the application actual need.

-Strip can’t apply to outdoor if does not make waterproof finish,in case of short circuit or electric spark.

-Be aware of the heat dissipation. Do not install the strip at where is high temperature affected and poor heat dissipation condition.

-Soft solder trims available to connect the strip without heat solder.