Design Features

-Variable input voltage range from DC5V-DC24V, support all LED products with voltage in this range.

-USB port to load program data, serial connect port to enlarge the controller cascade reach out 10pcs which has 120CH in total.

-IC component involves superior micro control unit,enable the controller with memory store function,installation software on PC end available in English version, light running effect can be programmed by the software, the controller is able to run the programmed light effect after load the program;

-Output channel is 12CH for single controller,output current is 5A max for each CH;

-Single controller max load is 12CH single color light or 4CH RGB light.

-Function enable operation procedure programmable；

Tech Parameters:

Application

-Suitable for RGB led light strip, RGB led module, RGB led light bar,single color also supportable to run in dynamic effect.

Installation instruction

-Connect the supportable load of facility in priority, check out the wires connection to ensure no short circuit problem.

-Single color load connection:

Inset the wire of negative into the output channel L1-L12, the wire of positive into the V+ pole of the controller.

-RGB color load connection:

Wires of R,G,B insert separately into the L1-L12 with matching the color direction on controller, wire of positive inserts into V+ pole of controller.

-Serial connection of controller

Number the controller by the switch at the backside of the controller,1st controller press down the Arabic number 1,2nd press down the Arabic number 2, 3rd press down 1 and 2, 4th press down 3, 5th press down 1and3, 6th press down 2and3, 7th press down 1-2-3,8th press down 4, 9th press down 1and4, 10th press down 2and4.

Output signal wire start from the first pole of 1st controller and connect the back follow controller with wire insert into first pole, till the last one, the back circuit wire start from last controller 2nd pole and connect the prior controller 2nd pole till the 1st controller, back circuit wire end in the last pole of 1st controller.

-Serial connection of controller

Program software installation and programming

-Install the software on PC end, connect the controller with PC by cyber cable. Run the program on PC to access the programming interface.

-L1-L12 on the interface refer to output channel, K1 refer to 1st controller,if program for serial connection,click add channel icon to add on the balance controller(K2-K3...K10)

-The dot on the interface in white color refer to light on, in black color refer to light off, click the dot can change the dot color.