Design Features

-Big size 5050 SMD LED mounted, golden wire with copper base, CRI>75;

-DC12V Constant voltage circuit for flexible cut off as application need;

-Encased by silicon rubber tube with either side sealed by rubber cap for waterproof finish. Enable outdoor scenario application without damage to the light.

-PWM control 256 grade grayscale , control signals through external MCU/controller to achieve various colorful effects.

-Every 3LED drive by one IC as a union, strip can be cut at the solder joint point.

-The number of the cascade point maximum reach out 1024points.

-FPCB adopt double side copperplate width is 10mm and thickness is 35/35 2Oz;

-Strip maximum length up to 5meters, without voltage dropping matter;

RM Detail:

Optical and Physical Specification:

Optoelectronic Parameters:

Application and Installation Instruction

-Suitable for indoor cell roof invisible light decoration, bedroom background light,light decoration in the yard.

-Screw on the clasp on the object where you intend to apply the strip, hang or twine over on the tree if used for yard decoration.

-Kick the strip inside the clasp to make the strip clipped by clasp.

Tips:

-Strip can be cut off from the solder joint mark, according to the application actual needed. A end cap accessory required after the strip being cut to ensure the waterproof function;

-Do not sink the strip inside the water;

-Be aware of the heat dissipation. Do not install the strip at where is high temperature affected and poor heat dissipation condition;

-Free from the strong electromagnetic covered zone, in case any signal interruption problem.